1. Model No.: ND-DH-5Z
2. This automatic positioning armature dynamic balancing machine can find and stop at unbalanced position automatically. No need to mark on armature (such as reflective sheet, black mark and so on).
3. This machine balance armature carries out the correction by adding weight to the armature.
4. This machine can test armature imbalance automatically.
5. this machine can automatically do positioning for the armature.
6. PLC control.
This machine is suitable for Armature dynamic balancing (refer to below machine's specifications). The correction way is adding weight to the armature. It's suitable for small armature. Machine can be customized as per customer's armature. The machine is widely used in the motor field, such as wiper motor, vacuum cleaner motor, mixer motor, window lifter motor, condenser motor, power tool motor, DC motor, etc.
Armature lamination length:10~200mm
Armature diameter range:Max 200mm
Automatic Positioning Armature Dynamic Balancing Machine Adding Weight
This machine automatically measures the unbalancing amount of the armature, automatically stops the armature at the unbalancing position, then operator needs to stick the balancing mud onto the unbalancing position manually. Operator doesn't need to make any mark on the armature(such as sticking reflective sheet, black mark, etc.)
1. Put in machining armature manually
2. Carry out armature's imbalance testing automatically (can start by manual), display and maintain testing data automatically, at the same time, it can display angular difference of left and right imbalance point, simple and easy operation, furthest to avoid faults during operation.
3. Stop at adding weight point (left) automatically, finish adding manually, change to the next adding weight point(right), finish adding manually, test again, and complete balancing adjustment.
4. Take out well-balanced armature, put in unbalanced one.
1. Professional testing machine box
2. High sensitivity hard support measure frame
Machine's efficiency of operations:
1. Relate to the initial imbalance volume the balancing volume of armature.
2. Cycle of measurement is 6s/piece; usually measure 2-3 times.
1. No need to mark on the armature (such as reflective sheet, black mark an so on)
2. Imbalance point positioning automatically
3. Low operation skill requirement to staff
4. Reduce the complexity of the machine operation